Halex 94107 Rigid To Rigid Corner Pull Elbow, Zinc, 3/4-in.

A corner pull elbow is an essential fitting for electricians and DIY installers who need to route wire through sharp bends in threaded rigid or IMC conduit runs. This Halex 94107 model uses zinc die-cast construction and is suitable for indoor or outdoor use. The 90-degree angle design facilitates smooth wire pulling through otherwise difficult corners, reducing strain on conductors and lowering the risk of insulation damage during installation.

The removable cover grants clear access to the interior, allowing you to guide wires through the bend without obstruction or resistance. This design simplifies work in tight spaces where cramped conditions would otherwise make wire pulling difficult and time-consuming.

Features and Benefits

• Removable Cover: Opens to provide easy access and allow wire pulling without obstruction.
• Zinc Die-Cast Construction: Durable material for both indoor and outdoor environments.
• 90-Degree Angle: Designed specifically for sharp directional changes in conduit runs.
• 3/4-Inch FPT Connection: Female pipe thread fittings on both ends for secure installation to rigid or IMC conduit.
• UL Listed: Meets electrical safety standards.
• Reduced Installation Strain: Minimizes wire damage and labor effort compared to pulling through standard elbows.

Specifications

• Brand: Halex
• Model: 94107
• Size: 3/4-inch FPT x FPT
• Angle: 90 degrees
• Material: Zinc die-cast
• Connection Type: Female pipe thread
• Suitable For: Rigid conduit and IMC (Intermediate Metal Conduit)
• Environments: Indoor and outdoor
• UL Listed: Yes
• Packaging: Bulk packed